Braking resistor 12000W HIPAR for ECOROTE wind turbine

12000W HIPAR Braking Resistor for ECOROTE Wind Turbine

The HIPAR braking resistor, rated at 12000W, is a key component for any wind energy system using an ECOROTE turbine. Its function is to dissipate excess electrical energy as heat, particularly during strong winds or when the turbine is disconnected from the grid or battery bank.

Function and Operation

In a wind energy system, when production exceeds consumption or storage capacity, a dump load is essential. The braking resistor fulfils this role by absorbing surplus power, preventing turbine overspeed and the mechanical damage that could result. With a nominal capacity of 12000W, this resistor is sized for the corresponding ECOROTE wind turbine models.

Compatibility

This braking resistor is specifically referenced for the ECOROTE wind turbine range. Before ordering, it is recommended to verify compatibility with your exact turbine model and wind charge controller. If in doubt, our technical team is available to assist you in selecting the right component for your installation.

Installation and Use

The braking resistor must be installed in conjunction with a wind charge controller (dump load controller), which automatically manages the dissipation of excess energy. It should be mounted in a well-ventilated location or on a suitable heat sink, as it can reach high temperatures during operation. Installation must comply with applicable electrical standards and regulations.

A Wattuneed Accessory

Sold under the Wattuneed brand, this braking resistor is available for the French and Belgian markets. It is suitable for professional installers and experienced DIY users looking to complete or secure their ECOROTE wind turbine installation.