Battery cable 2x50mm² - 2m

Dual Conductor Battery Cable 2x50mm² – 2 Metres

In any solar installation with energy storage, the quality of the cabling between the battery and the power conversion equipment is a key factor for both safety and system performance. The 2x50mm² battery cable from Wattuneed addresses this requirement with a substantial 50mm² cross-section per conductor over a 2-metre length.

A Cable Sized for Storage Systems

The 50mm² cross-section per conductor helps minimise voltage drops and resistive losses when carrying the high currents associated with battery charge and discharge cycles. This cable is particularly well suited to installations using LiFePO4, Li-ion or AGM batteries of medium to high capacity, paired with inverter-chargers or solar charge controllers.

The dual-cable configuration (positive and negative) simplifies wiring and ensures consistent conductor lengths on both poles, contributing to the electrical balance of the circuit.

Ease of Installation

At 2 metres in length, this cable provides sufficient reach for most enclosure or technical room configurations. It is suitable for professional installers looking for a ready-to-fit cable, as well as DIY users carrying out their own off-grid or hybrid solar installation.

The fixed 2-metre length allows precise planning of the cable run between the battery and the inverter or distribution board, avoiding unnecessary slack or mechanical stress on terminals.

Compatibility and Applications

This battery cable is compatible with all equipment using standard terminal connections. It integrates seamlessly into off-grid solar systems, hybrid installations, and grid-tied systems with battery storage.

For installations requiring different lengths or cross-sections suited to specific power ratings, Wattuneed offers a range of additional cable references in its cables and connectors category.

Technical Specifications