Victron Battery protect BP 48-100 View full size

Victron Battery protect BP 48-100

Victron energy

181,50 € tax incl.

Options

The Victron Energy BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

With 7 segment LED display: easy to set up. 
 

logo victron energy          

More details

More info

" The Victron BatteryProtect : disconnects the battery from non essential loads "

 

The Victron Energy BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

 

Description

 

Victron batteryprotect 48-100

A special setting for Li-ion batteries

 

In this mode the Battery Protect can be controlled by the VE.Bus BMS.


Ultra low current consumption

 

This is important in case of Li-ion batteries, especially after low voltage shutdown.
Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.


Over voltage protection 

 

To prevent damage to your sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 16 V respectively 32 V. 


Ignition proof 

 

No relays but MOSFET switches, and therefore no sparks.


Delayed alarm output 

 

The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 15 seconds. Starting the engine will therefore not activate the alarm. The alarm output is an open collector output to the negative (minus) rail, max. current 500 mA. The alarm is typically used to activate a buzzer and / or lamp. 


Delayed load disconnect and delayed reconnect 

 

The load will be disconnected 90 seconds after the alarm has been activated. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected.
The load will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.


Technical Features

  

Battery ProtectBP 48-100
Maximum continuous load current100 A
Peak current250 A
Operating voltage range24-64 A
Current consumptionWhen on: 2mA When off or low voltage shutdown: 0,8 mA
Alarm output delay
12 secondes
Maximum load on alarm output50 mA (short circuit proof)
Load disconnect delay
90 seconds
(immediate if triggered by the VE.Bus BMS)
Load reconnect delay30 secondes
Default thresholds
Disengage: 10,5V or 21V Engage: 12V or 24V
Operating temperature range
Full load:-40°Cto +40°C (up to 60% of nominal load at 50°C)
Poids0,8 kg
Dimensions (H x L x P)62 x 123 x 120 mm

 

Battery protect de victron

 

 

 

(Datasheet on download)