Epever PWM LandStar Serie 12V / 24V


67,77 € tax incl.

10A - 20A - 30A Epever charge regulator 12V/ 24V. 
New generation programmable solar charge controller. Adopt aluminum heat sink which enables the reliability in high temperature enviroments.

PWM solar controllers protect your batteries from discharges and overcharging, ensuring optimum service life.



stock quantity : 6

More details

More info

" LS1024B - LS2024B and LS3024B Solar regulators " 


Epsolar’s new generation programmable solar charge controller. Adopt aluminum heat sink which enables the reliability in high temperature enviroments.




  • Capacity: 10A, 20A or 30A
  • Operating voltage: 12V or 24V
  • Temperature compensation
  • Warranty: 2 years
  • Technology: PWM
The theoretical charging of a lead acid battery operates in three phases:
lead battery operating chart



- Phase 1: the current is limited to a rate of about 1/5 of the rated capacity. The voltage increases gradually until it reaches its maximum regulated threshold to 2.35 V / element.

- Phase 2 : the charging voltage is regulated to 2.35 V / element, the charging current then decreases to less than C/100. This phase should last up to 20 hours, the voltage must not stay above 2.26 V longer. The battery is chargedat the end of this phase

- Phase 3: once the battery is charged (after about 20 hours of charging) it switches to trickle charge (Floating) to keep it at 100% load. Then the voltage applied to the battery is around 2.26 V / element.



  • Solar home system

    charge regulator epever pwm 10A

  • Solar lighting system
  • Solar road signals
  • Solar surveillance
  • Solar RVs and boats
  • Small solar power station



  • Three system voltage configuration : 12V, 24V or 12V/24V auto work 
  • High efficiency PWM charging with temperature compensation
  • 3 LEDs shows PV charging, battery and load status
  • External temperature sensor interface
  • RS-485 bus communication
  • Open standard Modbus communication protocol
  • Software update function

Electronic protections


  • PV array short circuit
  • Overcharge 
  • Load short circuit
  • PV reverse polarity
  • High voltage transients
  • Over discharge  
  • Load overload 
  • Battery reverse polarity
  • Overheating


Nominal system voltage12/24VDC
Rated battery current10A20A30A
Maximum PV input voltage50V
GroundingCommon positive
Temp. compensation-3mV/?/2V?25? ref?
Equalize charging voltageSealed: 14.6V,  Flooded: 14.8V,  User-defined: 9~17V
Boost charging voltageGel: 14.2V,  Sealed: 14.6V,  Flooded: 14.8V, User-defined: 9~17V
Float charging voltageGel /Sealed /Flooded: 13.8V,  User-defined: 9~17V
Low voltage reconnect voltageGel /Sealed /Flooded: 12.6V,  User-defined: 9~17V
Low voltage disconnect voltageGel /Sealed /Flooded: 11.1V, User-defined: 9~17V
Mounting holes126mm147x50mm190x70mm
Working temperature-35?~+55?
Storage temperature-35?~+80?
Humidity?95% (NC)

Monitor software 


Please, download the last version of the monitor software here



More powerful function via MT50 

display epsolar


Diversified load control modes : Manual, Light ON/OFF, Light ON+ Timer, Time Control ? Battery type selection: Gel, sealed, flooded and User type

Real-time monitor
Programmable parameters
LVD or SOC load disconnect function
Energy statistics function


Charge power30A
Voltage12V / 24V
Maximum PV input voltage50 V